![]() Think about flying a drone at 6 ft above the ground over hilly county and your feedback is delayed by 1 sec! Factor in the added delay of the Proma that uses relays on the Up and DOWN and you will be luck to get stable operation at 30 IPM or less. The pure speed of MACH THC keeps practical response down to about 60 IPM in Z speeds on a fast Z. It's just not capable of responding or moving fast enough to keep up with warps while you cut at over 200 IPM. Once you have it working you will be disappointed in the ability to cut the thin stuff. ![]() ![]() The code should seek the home swtich closure (from touching the metal and moving the torch up and the g code sequence in the POST should lift it first to the top of the material (switchOffset distance), then up the programmed Pierce Height have defined in SheetCAM, fire the torch and then plunge down to the defined Cut Height value. You need to use a POST (like the THC 300 or the MP1000-THC) that is setup for the auto touch off sequence.either the G28.1 or the G31 probe sequnce. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |